Half European Skull

A 3D printed half deer skull with the bullet anchor antler mount system. This is the regular size, an average size skull for average size antlers. It comes with a bracket so it mounts flat on the wall, so no wall mount is needed. A drill bit and screws are included, plus screws and drywall anchors for hanging it on the wall. Choose a left or right facing half.

Instructions:

1. Drill the center of the antler bases with a 1/8" drill bit.
2. Attach the bullet anchors to the antlers using a #8 wood screw.
3. Slide the bullet anchors into the skull at your desired rotation.
4. Display however you wish!

Hanging it on the wall:

1. Mark where you want the skull on the wall.
2. Push a Phillips screwdriver into the drywall at each mark to make a small starter hole. The anchors won't screw into the wall without this step.
3. Screw the drywall anchors into the starter holes with the screwdriver until they sit flush with the wall.
4. Line up the skull and screw it into the anchors with the included screws.